Awning Bracket Crafter (2017+) / TGE

Advantages of the Sequoia Roof Rack Awning Brackets for your Crafter (2017+) / TGE

The awning brackets allow you to mount a wall-mounted awning on the side of your Sequoia roof rack without having to drill into your Volkswagen Crafter (2017+) / MAN TGE camper.

These brackets are specifically designed for wall-mounted awnings such as the Thule Omnistor 5200 and Fiamma F45s, and exclusively support wall-mounted awnings (no roof-mounted awnings). Roof rails and a Sequoia roof rack are required for installation.

Each set includes three awning brackets, which are sufficient to mount one awning. The stated price refers to one set. Choose the awning length based on your vehicle's dimensions. For the best appearance, choose an awning that does not extend beyond the rear compartment. The awning and brackets can also be added at a later stage of the camper's conversion.

Recommended awning lengths for Volkswagen Crafter (2017+) / MAN TGE:

• L2: approx. 200 cm

• L3: approx. 300 cm

• L4: approx. 400 cm

Installation Requirements

Installation requires roof rails and a Sequoia roof rack. The process is simple and flexible, with no additional drilling required. The awning brackets are mounted directly to the roof rails and the load bar of the roof rack.

Sequoia Awning Bracket Specifications

• 3 brackets per set for one awning
• Screw mounting
• Stainless steel mounting hardware

Product Note

Regulations for roof mounting may vary by country. It is your responsibility to ensure that you check the applicable requirements in your country. Vanstudio accepts no liability for compliance with regulations or any problems that may arise with this product.

Compatible with

• Volkswagen - Crafter 2nd generation (2017+)
• Dethleffs - Globetrail Performance
• Volkswagen - Grand California 600/680
• Westfalia - Sven Hedin
• MAN - TGE (2017+)